I am back from a trip to the west coast.
After completely removing and re-wiring my bilge pumps I was stunned to find them not working properly. Well, I've fixed everything. It turned out there were two bad circuit breakers, and I also discovered that when power is applied, to the automatic circuits, the pumps run for 6-8 seconds. I was scratching my head wondering why they came on in an empty bilge.
So--both pumps are mounted, set on automatic, and I have two independent circuits for manual operation. I can trust my pumps are working--for the time being. I still would like to update these in the future to a smaller lower pump to remove more water, and a higher volume non-submersible pump, and a also an engine driven high volume pump.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment